SC-AIRCRAFT & Metal Cleaner Concentrate 

                               DESCRIPTION: SC-AIRCRAFT & Metal Cleaner Concentrate is an advanced non-ionic  surfactant system especially formulated for use on both ferrous and non ferrous, soft metal surfaces such as aluminum, cadmium and brass. SC AIRCRAFT & Metal Cleaner causes long chain hydrocarbon soils such as  JA or JP fuels, gear lubricants, cutting fluids, carbon soot, hydraulic fluids  and other soils, to release from the surface so that they can be rinsed away  with water. SC-AIRCRAFT & Metal Cleaner is water-miscible, and has  dielectric and anti-oxidant properties. 

CERTIFICATIONS:  

  • US Air Force MIL-PRF-87937D Type IV 
  • US Navy MIL-PRF-85570C, Type II
  • Airbus AIMS09-00-002 
  • BOEING D6-17487, Revision N
  • EU REACH Pre-registered 
  • New York City Transit S-70-01-96, Revision D – Bus Wash Alkaline Cleaner
  • Chicago Transit Authority #1467820 – Aluminum Wheel Cleaner
  • Complies with OSHA 29-CFR Ch. XVII 1910.1200 and 40 CFR Ch. 1, Subparts C & D
  • Complies with USEPA 600, 4-90, 027 for aquatic toxicity 
  • Complies with USEPA 601 & 602 for VOC testing
  • California SCAQMD – Clean Air Solvent, Method 313-91
  • NSN 6850-01-433-0873 (5 gal.); 6850-01-429-2371 (55-gal.); 6850-01-506-7708 (bulk) 

                              INSTRUCTIONS: SC-AIRCRAFT & Metal Cleaner is a concentrate and may be used full strength or diluted with water depending on the specific application. Less  product may be necessary with increased temperature (110°F preferred),  dwell time or agitation. Spray apply product and allow to dwell for 5 minutes,  agitate with a nylon brush for tougher soil, then rinse thoroughly with water  to remove soil and residual product. 

         Suggested Dilutions: Heavy Cleaning 50% – 30% 

                                                 Average Cleaning 20% – 10% 

                                                      Routine Maintenance 5% – 2.5% 

Note: For polymerized soil use, BAC 5750 approved SC-EZ-Solv Safety Solvent to wipe-on, wipe-off most tar, fluids, lubricants or galley waste. 

SAFE CARE® PRODUCTS ARE: 

 Non-toxic 

 Non-reactive 

 Non-carcinogenic 

 Readily biodegradable 

 Derived from renewable resources 

 Safe to use, store and dispose of 

SAFE CARE® PRODUCTS DO NOT CONTAIN: 

 Petroleum distillates 

 Terpenes 

 Synthetics

 Builders & reagents

 Caustics  

 

BASIC PROPERTIES: 

Appearance: Clear, light amber liquid 

Odor:Mild coconut surfactant 

Water Solubility:100% Soluble 

Boiling Point: 100ºC (212ºF) 

Flash Point: None 

Specific Gravity: ~1.00 @60/60°F 

pH Range: 8.2 – 8.8

                                        The information contained herein is believed to be correct including  

                                                                        test data conducted under controlled laboratory conditions. Users of  

                                                                       SAFE CARE products should perform their own test(s) to determine  

                                                         the suitability of the product for their specific application(s).  

A Division of GEMTEK® Products