SC-1000 Aqueous Cleaner Concentrate 

DESCRIPTION: SC-1000 Aqueous Cleaner Concentrate is our most versatile and powerful  non-ionic surfactant system used in a variety of industrial and commercial  applications. Comprised of fatty alcohols, free fatty acids and fatty esters,  SC-1000 is a colloidal solution that creates a unique hydrocarbon release  agent that can tolerate tremendous soil load. The powerful micelle cleaning  action of SC-1000 will cause long chain hydrocarbon soils including fats,  greases, oils, proteins and sugars to repel from the surface so that they can  be rinsed away with water, without damaging or reacting with the cleaning  surface. SC-1000 is not a typical caustic detergent or petroleum solvent,  therefore it will not damage or react with the cleaning surface. SC-1000 meets with the following requirements:  

 USEPA Design for the Environment (DfE)

 USEPA National Oil & Hazardous Substances Pollution Contingency Plan (NCP) ¹ 

 USEPA Vessel General Permit (VGP) Compliant 

 USDA BioPreferred^® Program 

 EU REACH Pre-registered 

 CEFAS Reg. 25334 North Sea 

 USDA A1 General Cleaning & L1 Drain/Sewer Acceptable 

 California’s SCAQMD as a Clean Air Solvent. 

 OSHA 29-CFR Ch. XVII 1910.1200 and 40 CFR Ch. 1, Subparts C & D 

 USEPA 600, 4-90, 027 for aquatic toxicity 

 USEPA 601 & 602 for VOC testing 

 NSN 6850-01-474-1273 (5 gal.); 6850-01-474-1311 (55 gal.) 

¹SC-1000™ is on the USEPA NCP Product Schedule under Surface Washing Agents. This listing does not mean that  EPA approves, recommends, licenses, certifies or authorizes the use of SC-1000 on an oil discharge. The listing means only that data has been submitted to EPA as required by Subpart J of the NCP § 300.915. 

INSTRUCTIONS: Rinse surface to remove loose particulate soil before cleaning. The product  should be diluted with water depending on the specific application. Less  product may be necessary with increased temperature, dwell time or agitation.  Rinse with water to remove soil and residual product. Water-break or sheeting  action should be observed on smooth hard surfaces. 

Suggested Dilutions: Difficult Cleaning 50% – 20% 

Average Cleaning 20% – 5% 

Light Cleaning 5% – .5%

SAFE CARE_® PRODUCTS ARE: 

 Non-toxic 

 Non-reactive 

 Non-carcinogenic 

 Readily biodegradable 

 Derived from renewable resources 

 Safe to use, store and dispose of 

SAFE CARE_® PRODUCTS DO NOT CONTAIN: 

 Petroleum distillates 

 Glycol ethers 

 Terpenes 

 Synthetics 

 Builders & reagents 

 ^Caustics

BASIC PROPERTIES: 

Appearance: Clear, light amber liquid 

Odor: Mild surfactant 

Water Solubility: 100% Soluble 

Boiling Point: 100ºC (212ºF) (ASTM D1120) 

Flash Point: None (ASTM D93 Closed Cup) 

Specific Gravity: ~1.01 @60/60°F (ASTM D891) 

pH Range: 9.9 – 10.9 (ASTM E70) HLB: 13.85 

The information contained herein is believed to be correct including  test data conducted under controlled laboratory conditions. Users of  SAFE CARE products should perform their own test(s) to determine  

the suitability of the product for their specific application(s).  

A Division of GEMTEK_® Products